Since igus® launched the snap-open and (two-piece) e-tube in the mid 80s, many additional parts and innovations have supplemented the product range. e-tubes are usable in areas with hot chips, dirt and dust generated in wood processing, steel works, pulp factories, textiles, agriculture, coal-fired plants and in many other unfavorable environmental conditions. Go for the cost efficient, alternative Series R for higher speeds.
For higher speeds and a silent operation
To open the E.Tubes, prize the lid with a screwdriver and then simply remove.
You can find the right e-chain® quickly by entering concrete parameters and with the aid of a comparison table.
Joining and separating of the E-Tubes.
Applications in various industrial sectors and in the igus® test laboratory.
Protection for cables and tubes against chips (even hot chips)
Rugged and tight
Space-saving with good ratio of
inner to outer dimensions
Modular interior separation options
Small pitch for low-noise, silent operation
Very small radii possible through small pitch
Smooth, chip-repellant exterior contour
Removable lid for shortening the installation time
Double stop dog system for longer unsupported lengths
KMA mounting brackets with potential for "all-round" fastening
Timber Processing Machines
Long travels in many industrial sectors
Theater and entertaining industry
General mechanical engineering etc.
In all areas exposed to dirt and chips
iF Design Award for series R117/R118 and series R68
ESD classification: electrically conductive ESD versions upon request
UL94-V0 classifications upon request
e-tubesmade of igumid HT: hot swarf (up to 850°C) cannot burn in. Available as custom design upon request.